Half the key is still in your hand. The other half stayed behind in the ignition when it snapped, and now the dash won't light and the wheel won't unlock no matter how carefully you nudge what is left.
Where the hardware allows it, a replacement or serviced ignition cylinder is pinned to match the key already in your pocket, rather than handing you a second key to keep track of. The same thinking extends to the doors and trunk: if they already share a key with the ignition, the locksmith keeps that arrangement intact, so one key still does everything it did before the visit began.
Sound familiar?Preston
Ignition Lock Repair · Preston
Scene 1
Behind the part of the ignition a key touches sits an electrical switch with its own positions, off, accessory, on and start, and a mechanical steering lock that engages when the key is removed. The locksmith checks how the barrel behaves at each stop: whether it reaches start cleanly, whether the wheel locks and releases as it should, and whether the transition back to accessory is smooth. A fault confined to one position often narrows the cause before any part comes off the vehicle.
Scene 2
When the barrel itself needs to come out, it is removed from the housing and its wafers are reset to match the key already in use, following that vehicle's own service procedure rather than a generic pin-and-follower method. Reassembled and tested through every position, the repaired cylinder answers to the same key that opened the door on the way to the vehicle, so nothing else in the owner's pocket needs to change.
Scene 3
A cylinder that has just been serviced benefits from the same light touch that kept it healthy in the first place: whatever lubricant the vehicle's own service information calls for worked into the keyway every so often, since some ignitions specify grease rather than a dry product. Wipe debris off the key itself before each use, and retire a key that has started to look rounded or thin, well before it becomes the reason for another visit.
What shapes the quotePreston Locksmith Co.
FeesSame any hour
A single worn key is a common starting point after buying used, and the visit usually has two parts: reading the existing wafers so a crisp new key can be cut, and deciding whether the barrel itself needs a service given whatever wear the previous owner's key left behind. Bringing whatever paperwork came with the sale helps confirm ownership before any work begins.
Pliers, screwdrivers used as levers, and excess force in general tend to bend the key, mark the housing or snap something inside the barrel rather than resolve the underlying wear. A stuck ignition responds better to being read and serviced with tools built for the mechanism than to being pried at, so it is worth waiting rather than working through it alone.
In most cases, yes. Hooked and spiral extraction tools reach in and draw the broken piece out along the path it entered, rather than pushing it further in. Once it is clear, the cylinder is checked for the wear that likely caused the break in the first place, and a fresh key is cut to replace both broken pieces before the vehicle is handed back to you.
WaterlooOntario
Every square is one home in a hundred.
On-site assessment preferred · (226) 807-5217, open 24/7
